Rank: Member
Groups: Registered Users, Subscribers
Posts: 10
|
Hi All, This weekend I replaced that ugly OEM Reservoir tank on my 17 GT350 with a black powder coated one from Shelby American. Here's my question to anyone who has installed the same or similar tank. The old plastic OEM tank had a min and max fill line on the front. This new one from Shelby does not have any marks indicating how full to fill it with coolant. I saved most of the coolant from the old tank and added that and a little more to compensate for what I spilled during the install, but how do you know if it is filled with the correct amount. Has anyone else installed one of these and if so what do you do to check for proper coolant level? Thanks All
|
|
|
|
|
|
Rank: Advanced Member
Groups: Registered Users, Subscribers
Posts: 613
|
I installed the same tank. Was very careful removing original tank not to spill a lot of coolant. I lost very little and transferred it to the Shelby tank. I added some extra then measured it with a clean wood stick, in this case a tongue depressor. Marked it and put in my tool box for future reference.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The Team Shelby Board uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close